Posted on November 4, 2017November 4, 2017 by AdminMore build pictures Here’s some more photos from the final stretch of this project. We decided to adjust the center trim piece which sadly means some more painting. lol Colossus – Rapberry Pi Single Board Computer Relay Bank #1 and the breadboard to connect Colossus to the aquarium light relay module. Overhead shot of Relay Bank #2 and the MCP23017 driver board. The hookup board to connect the RJ45 sensors to the PI. The PIR side is not currently hooked up to a pi. Colossus’s HDMI splitter, we will eventually add another one of these for Guardian. To make connecting the devices up to Colossus easier, we labeled and put dummy plugs into the outlets we are going to use. RJ45 jacks for connecting two DS18B20 waterproof probes and two passive infrared sensors. Top of the canopy. We ran a USB extension cable from each pi to increase range for our wireless keyboards. Backside of Guardian LCD monitor showing the driver board Backside of Colossus LCD monitor showing the driver board Inside Guardian side of the canopy with the lights on. Inside Colossus side of the canopy with the lights on. Colossus’s smart mirror with Kodi media center. Back of the canopy with the lights on. Colossus uses a 10/100 switch to connect to the internet. The white cables are network cables to both Raspberry Pi. The power blocks are the power supplies to the LCD monitors.